Connect TilliT Edge to a Wireless Gateway
Once the TilliT Edge is operational, you will want to connect it to the wireless gateway. To do so, you will need to decide how the wireless gateway will connect to the edge. See below for how this can be done.
TilliT Edge is shipped for this architecture out of the box. By connecting the Wireless Gateway to the TilliT Edge device on Port B, the devices will be able to communicate with each other. If using this method, skip to configuring TilliT where the IP address of the Wireless Gateway is 10.10.0.5.
If your install requires this architecture, then small adjustements will need to be made to ensure TilliT Edge can communicate with the wireless gateway. To do so, you must consult with your IT team to determine if the device will need a static or DHCP IP. Follow the relevant steps below
Static IP
1. Navigate to System Config
2. Select Ethernet
3. The default is for DHCP to be off, leave this as it is. Now set the IP, Subnet(SN) and Gateway (GW) according to your LAN settings.
DHCP
1. Navigate to System Config
2. Select Ethernet
4. Return to the Ethernet sceen to check for the assigned IP of the device.
Configure TilliT
Now that TilliT Edge and Wireless Gateway are able to see each other, TilliT Edge needs to be configured to connect to the Gateway. Follow these steps.
1. Navigate to Settings -> Edge and select the TilliT Edge that will connect to the wireless gateway.
3. Click on save. The next thing to do is to update TilliT Edge with the new configuration by pressing the Publish Configuration button.
4. It may take a minute or two for TilliT Edge to update the connection status, but you will know that the datasource has successfully connected when you see the blue tick on the connected status (refresh the screen to update).
Last updated
